METHOD STATEMENT MEGGER TESTING FOR POWER CABLES & BRANCH CIRCUIT WIRING

METHOD STATEMENT FOR WIRES AND CABLES INSTALLATION

METHOD STATEMENT MEGGER TESTING FOR POWER CABLES & BRANCH CIRCUIT WIRING EQUIPMENT AND TOOLS:- 1.       Megger Instrument shall be having valid calibration. 2.       Megger-with range 500V/1000V shall be used for conducting the test.           Megger range 500 V shall be used for Wire testing           Megger range 1000 V shall be used for Cable testing… Continue reading METHOD STATEMENT MEGGER TESTING FOR POWER CABLES & BRANCH CIRCUIT WIRING

METHOD OF STATEMENT FOR SLAB ON GRADE

Concreting-of-reinforced-concrete-slab-photo-by-the-author-of-the-paper

METHOD OF STATEMENT FOR SLAB ON GRADE Summary:   This Method of Statement includes the following; I.  All Slab on Grade  II. Approved Materials:     1. Polythelene Sheets Transmittal # C-004     2. Wiremesh Transmittal # C-454 (for approval)     3. Seifban TC Transmittal # G-456 or Guard 20 TC Transmittal #G-          0478  1.… Continue reading METHOD OF STATEMENT FOR SLAB ON GRADE

METHOD OF STATEMENT FOR LARGE VOLUME REPAIRS TO DAMAGED REINFORCED CONCRETE ELEMENTS

Method-Statement-for-Concrete-Repairing

METHOD OF STATEMENT FOR LARGE VOLUME REPAIRS TO DAMAGED REINFORCED CONCRETE ELEMENTS Summary:   This Method of Statement includes the following; For large volume repairs to damaged reinforced concrete elements particularly where access is restricted and where vibration of the placed material is difficult or impossible. 1. Preparation   Defective concrete surfaces must be cut-back… Continue reading METHOD OF STATEMENT FOR LARGE VOLUME REPAIRS TO DAMAGED REINFORCED CONCRETE ELEMENTS

METHOD OF STATEMENT FOR BELOW GRADE SURFACES OF CONCRETE FOOTING & UNDERGROUND PROPOSED MASONRY WALL

Building Footing

METHOD OF STATEMENT  FOR BELOW GRADE SURFACES OF CONCRETE FOOTING & UNDERGROUND PROPOSED MASONRY WALL Summary:   This Method of Statement includes applied emulsified asphalt                      damp proofing applied on:           I.   Below grade surface of concrete footings foundation and columns.           II.  Exterior below grade surface of concrete foundation walls.           III. Backside of… Continue reading METHOD OF STATEMENT FOR BELOW GRADE SURFACES OF CONCRETE FOOTING & UNDERGROUND PROPOSED MASONRY WALL

METHOD OF STATEMENT FOR INTERLOCKING BLOCK AND CURB STONE

Interlocking pavers

METHOD OF STATEMENT FOR INTERLOCKING BLOCK AND CURB STONE Summary:   This Method of Statement applies to the following; Materials for Application; Pre-Cast Curb Stone Transmittal #C-0051Rev.1  Interlocking Block, Transmittal # C-0052 Aggregate Sub-base & Base Coarse Geotextile, Separation Layer-Geotextile Fabric 140 Transmittal # C-0047Rev.1 Mortar Soil Sterilizer  1. Delivery, Storage and Handling:   After… Continue reading METHOD OF STATEMENT FOR INTERLOCKING BLOCK AND CURB STONE

METHOD OF STATEMENT FOR TERRAZZO TILES AND SKIRTING

fixing the floor tile

METHOD OF STATEMENT FOR TERRAZZO TILES AND SKIRTING Summary:   This Method of Statement includes the following; Ordinary Portland Cement Sand Materials for Application; Pre-cast Terrazzo Transmittal # C-0051  1. Preparation   Examine areas to be installed with terrazzo tiles for compliance and tolerances affecting its installation. Control dust to prevent air pollution and protect… Continue reading METHOD OF STATEMENT FOR TERRAZZO TILES AND SKIRTING

METHOD OF STATEMENT  FOR WATER SUPPLY PUMP INSTALLATION

uPVC High Pressure Water Supply Piping System Installation Procedure

METHOD OF STATEMENT  FOR WATER SUPPLY PUMP INSTALLATION Open approved water supply drawings and locate the approved location of water  supply pump. Get and open instruction or installation manual of the pump and follow manufacturer instruction. Secure that all pumps accessories and main parts are intact and complete before installation. Also check pump motor winding… Continue reading METHOD OF STATEMENT  FOR WATER SUPPLY PUMP INSTALLATION

METHOD OF STATEMENT FOR MARBLE STONE INSTALLATION

Tiles

METHOD OF STATEMENT FOR MARBLE STONE INSTALLATION Summary:   This Method of Statement applies to the following; Marble Flooring Marble Stair Treads and Risers Marble Bases Marble Threshold Materials for Application; Marble Flooring, Locally Made (Trans. # C-0063) Marble Flooring Sylvia Light (Trans. # C-0063Rev.1) Marble Flooring Sylvia Medium Light (Trans. # C-0063Rev.1) Marble Flooring… Continue reading METHOD OF STATEMENT FOR MARBLE STONE INSTALLATION

METHOD OF STATEMENT FOR PLASTERING

METHOD OF STATEMENT FOR PLASTERING Summary: This Method of Statement includes the following; Internal Portland cement plaster: External Portland Cement plaster: Formed in Place plaster grooves in elevation: External Formed in place decorative cornices in building elevation Materials for Application; Portland Cement ASTM C150 Type 1 (Trans. # C-0238)(Submission for Approval). Sand Aggregate ASTM C… Continue reading METHOD OF STATEMENT FOR PLASTERING

Method of Statement for Unit Masonry

AAC BLOCK

Method of Statement for Unit Masonry      1.  SUMMARY:   This method of statement includes unit masonry                               assemblies consisting of the following: Concrete Masonry Unit 100mm Hollow and Solid 150mm Hollow and Solid 200mm Hollow and Solid 200mm Insulated Blocks (External wall) B. Mortar Materials /Mix  Materials to be used:                     Approved Companies: Al Falwa… Continue reading Method of Statement for Unit Masonry

Exit mobile version